revolution
- Creatore Discussione satty
- Data di inizio
HT Upgrade EMU
Upgrade EMU in Samsung DSR9500 VIA CI with HyperTerminal (only with loader 500 or 501).
Before you start uploading the new software into Samsung I would advise you to firstly remove all the cams or cards from it (if any are inside).
Click in Start->Programs->Accesories->Communications-> and open Hyper Terminal configured for sammy.
Choose "TRANSFER" and click in "Send File".
Choose "1KXmodem" for Protocol and click in "Browse".
Select Emu wich you want to upgrade in receiver e.g. "DSR9500_EMU_vX.X.X" and click in "Open".
After file is loaded "C\Documents and..." Don't press the button "Send", you will do it subsequently.
The things you have to do are :
1. Disconnect your Samsung using the switch on the rear.
2. In the front of Samsung keep pressed the "right arrow" (volume up).
3. Power up your Samsung on the rear switch and keep constantly pressed "right arrow" (volume up).
Keep the "arrow" pressed until the "3-01" appears on the display of receivers.
When you see "3.01" in display of receiver you can see in HT "Loading",now click in "Send" to start upgrading software (you have about 15 seconds to perform that operation).
Don't be hasty! Wait for entire process to terminate.
Process is terminated when on the Samsung a clock appears.
ciao
Upgrade EMU in Samsung DSR9500 VIA CI with HyperTerminal (only with loader 500 or 501).
Before you start uploading the new software into Samsung I would advise you to firstly remove all the cams or cards from it (if any are inside).
Click in Start->Programs->Accesories->Communications-> and open Hyper Terminal configured for sammy.
Choose "TRANSFER" and click in "Send File".
Choose "1KXmodem" for Protocol and click in "Browse".
Select Emu wich you want to upgrade in receiver e.g. "DSR9500_EMU_vX.X.X" and click in "Open".
After file is loaded "C\Documents and..." Don't press the button "Send", you will do it subsequently.
The things you have to do are :
1. Disconnect your Samsung using the switch on the rear.
2. In the front of Samsung keep pressed the "right arrow" (volume up).
3. Power up your Samsung on the rear switch and keep constantly pressed "right arrow" (volume up).
Keep the "arrow" pressed until the "3-01" appears on the display of receivers.
When you see "3.01" in display of receiver you can see in HT "Loading",now click in "Send" to start upgrading software (you have about 15 seconds to perform that operation).
Don't be hasty! Wait for entire process to terminate.
Process is terminated when on the Samsung a clock appears.
ciao