Il satracer 3 o sattracer 3 sarebbe un motore come questo?
https://www.clasf.it/motore-per-parabola-sat-control-sat-tracer-3-a-catania-37585643/
La prima cosa da fare è impostare correttamente lo zero.
- Con il ricevitore, dare il comando Goto Zero, talvolta chiamato anche Goto Reference.
- Verificare che l'indicazione del tubo motore sia arrivata esattamente a zero.
- Controllare che la parabola sia montata correttamente, in modo che polo - asse del motore - parabola siano esattamente allineati.
Sospetto che quest'ultimo non sia il caso.
A proposito: utilizzate i comandi di posizione USALS o Diseqc 1.2 GotoNn?
Tradotto da:
The satracer 3 or sattracer 3 would be a motor like this?
https://www.clasf.it/motore-per-parabola-sat-control-sat-tracer-3-a-catania-37585643/
First thing to do, would be to set zero correctly.
- With the receiver, give the command Goto Zero, sometimes also called Goto Reference.
- Check that the motor tube indication indeed has arrived at exactly zero.
- Check that the dish is mounted correctly, so that pole - motor axis - dish are exactly in line.
I suspect the latter is not the case.
By the way: do you use USALS? or Diseqc 1.2 GotoNn positional commands?
Ciao,
A33
Modifica, 16-12-2022:
Da aggiungere:
Anche il braccio dell'LNB dovrebbe essere esattamente in linea.
Normalmente dovrebbe essere tutto a posto, ma in rari casi il braccio non è più centrale; quindi controllarlo non fa male.
Edit, 16-12-2022:
To add:
The LNB arm should of course also be exactly in line.
Normally, that should be OK, but in rare cases the arm is not central anymore; so checking that does no harm.