=== START OF INFORMATION SECTION ===
Model Family: Seagate Momentus 5400.6
Device Model: ST9320325AS
Serial Number: 6VD14PBW
LU WWN Device Id: 5 000c50 01efb828c
Firmware Version: 0002SDM1
User Capacity: 320.072.933.376 bytes [320 GB]
Sector Size: 512 bytes logical/physical
Rotation Rate: 5400 rpm
Device is: In smartctl database [for details use: -P show]
ATA Version is: ATA8-ACS T13/1699-D revision 4
SATA Version is: SATA 2.6, 3.0 Gb/s
Local Time is: Mon Jun 19 18:50:46 2017 CEST
SMART support is: Available - device has SMART capability.
SMART support is: Enabled
=== START OF READ SMART DATA SECTION ===
SMART overall-health self-assessment test result: FAILED!
Drive failure expected in less than 24 hours. SAVE ALL DATA.
See vendor-specific Attribute list for failed Attributes.
General SMART Values:
Offline data collection status: (0x00) Offline data collection activity
was never started.
Auto Offline Data Collection: Disabled.
Self-test execution status: ( 0) The previous self-test routine completed
without error or no self-test has ever
been run.
Total time to complete Offline
data collection: ( 0) seconds.
Offline data collection
capabilities: (0x73) SMART execute Offline immediate.
Auto Offline data collection on/off support.
Suspend Offline collection upon new
command.
No Offline surface scan supported.
Self-test supported.
Conveyance Self-test supported.
Selective Self-test supported.
SMART capabilities: (0x0003) Saves SMART data before entering
power-saving mode.
Supports SMART auto save timer.
Error logging capability: (0x01) Error logging supported.
General Purpose Logging supported.
Short self-test routine
recommended polling time: ( 1) minutes.
Extended self-test routine
recommended polling time: ( 99) minutes.
Conveyance self-test routine
recommended polling time: ( 2) minutes.
SCT capabilities: (0x103b) SCT Status supported.
SCT Error Recovery Control supported.
SCT Feature Control supported.
SCT Data Table supported.
SMART Attributes Data Structure revision number: 10
Vendor Specific SMART Attributes with Thresholds:
ID# ATTRIBUTE_NAME FLAG VALUE WORST THRESH TYPE UPDATED WHEN_FAILED RAW_VALUE
1 Raw_Read_Error_Rate 0x000f 102 094 006 Pre-fail Always - 17850649
3 Spin_Up_Time 0x0003 099 098 000 Pre-fail Always - 0
4 Start_Stop_Count 0x0032 092 092 020 Old_age Always - 8639
5 Reallocated_Sector_Ct 0x0033 001 001 036 Pre-fail Always FAILING_NOW 2055
7 Seek_Error_Rate 0x000f 056 056 030 Pre-fail Always - 1005137560177
9 Power_On_Hours 0x0032 096 096 000 Old_age Always - 4254
10 Spin_Retry_Count 0x0013 100 100 097 Pre-fail Always - 0
12 Power_Cycle_Count 0x0032 097 037 020 Old_age Always - 3566
184 End-to-End_Error 0x0032 100 100 099 Old_age Always - 0
187 Reported_Uncorrect 0x0032 001 001 000 Old_age Always - 234
188 Command_Timeout 0x0032 100 058 000 Old_age Always - 25770262597
189 High_Fly_Writes 0x003a 100 100 000 Old_age Always - 0
190 Airflow_Temperature_Cel 0x0022 069 054 045 Old_age Always - 31 (Min/Max 27/31)
191 G-Sense_Error_Rate 0x0032 100 100 000 Old_age Always - 186
192 Power-Off_Retract_Count 0x0032 100 100 000 Old_age Always - 66
193 Load_Cycle_Count 0x0032 060 060 000 Old_age Always - 80275
194 Temperature_Celsius 0x0022 031 046 000 Old_age Always - 31 (0 14 0 0 0)
195 Hardware_ECC_Recovered 0x001a 054 044 000 Old_age Always - 17850649
197 Current_Pending_Sector 0x0012 100 100 000 Old_age Always - 2
198 Offline_Uncorrectable 0x0010 100 100 000 Old_age Offline - 2
199 UDMA_CRC_Error_Count 0x003e 200 200 000 Old_age Always - 0
254 Free_Fall_Sensor 0x0032 100 100 000 Old_age Always - 0
SMART Error Log Version: 1
ATA Error Count: 639 (device log contains only the most recent five errors)
CR = Command Register [HEX]
FR = Features Register [HEX]
SC = Sector Count Register [HEX]
SN = Sector Number Register [HEX]
CL = Cylinder Low Register [HEX]
CH = Cylinder High Register [HEX]
DH = Device/Head Register [HEX]
DC = Device Command Register [HEX]
ER = Error register [HEX]
ST = Status register [HEX]
Powered_Up_Time is measured from power on, and printed as
DDd+hh:mm:SS.sss where DD=days, hh=hours, mm=minutes,
SS=sec, and sss=millisec. It "wraps" after 49.710 days.
Error 639 occurred at disk power-on lifetime: 4242 hours (176 days + 18 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
04 71 04 9d 00 32 40 Device Fault; Error: ABRT at LBA = 0x0032009d = 3276957
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
42 00 00 3f f2 16 40 00 00:01:22.337 READ VERIFY SECTOR(S) EXT
42 00 00 3f f6 0f 40 00 00:01:18.849 READ VERIFY SECTOR(S) EXT
42 00 00 3f 02 00 40 00 00:01:11.557 READ VERIFY SECTOR(S) EXT
42 00 00 3f 00 00 40 00 00:01:11.503 READ VERIFY SECTOR(S) EXT
25 03 08 3f 00 00 40 00 00:01:11.499 READ DMA EXT
Error 638 occurred at disk power-on lifetime: 4242 hours (176 days + 18 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 00 06 f3 16 00 Error: UNC at LBA = 0x0016f306 = 1504006
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
42 00 00 3f f2 16 40 00 00:01:22.337 READ VERIFY SECTOR(S) EXT
42 00 00 3f f6 0f 40 00 00:01:18.849 READ VERIFY SECTOR(S) EXT
42 00 00 3f 02 00 40 00 00:01:11.557 READ VERIFY SECTOR(S) EXT
42 00 00 3f 00 00 40 00 00:01:11.503 READ VERIFY SECTOR(S) EXT
25 03 08 3f 00 00 40 00 00:01:11.499 READ DMA EXT
Error 637 occurred at disk power-on lifetime: 4242 hours (176 days + 18 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
04 71 04 9d 00 32 40 Device Fault; Error: ABRT at LBA = 0x0032009d = 3276957
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
42 00 00 57 f2 16 40 00 00:01:47.372 READ VERIFY SECTOR(S) EXT
42 00 00 57 f6 0f 40 00 00:01:43.918 READ VERIFY SECTOR(S) EXT
42 00 00 57 04 00 40 00 00:01:36.650 READ VERIFY SECTOR(S) EXT
42 00 00 57 02 00 40 00 00:01:36.636 READ VERIFY SECTOR(S) EXT
25 03 08 77 00 60 40 00 00:01:36.571 READ DMA EXT
Error 636 occurred at disk power-on lifetime: 4242 hours (176 days + 18 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 00 06 f3 16 00 Error: UNC at LBA = 0x0016f306 = 1504006
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
42 00 00 57 f2 16 40 00 00:01:47.372 READ VERIFY SECTOR(S) EXT
42 00 00 57 f6 0f 40 00 00:01:43.918 READ VERIFY SECTOR(S) EXT
42 00 00 57 04 00 40 00 00:01:36.650 READ VERIFY SECTOR(S) EXT
42 00 00 57 02 00 40 00 00:01:36.636 READ VERIFY SECTOR(S) EXT
25 03 08 77 00 60 40 00 00:01:36.571 READ DMA EXT
Error 635 occurred at disk power-on lifetime: 4241 hours (176 days + 17 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
04 71 04 9d 00 32 40 Device Fault; Error: ABRT at LBA = 0x0032009d = 3276957
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
42 00 00 57 f2 16 40 00 00:07:23.413 READ VERIFY SECTOR(S) EXT
42 00 00 57 f8 08 40 00 00:07:16.724 READ VERIFY SECTOR(S) EXT
42 00 00 57 6e 07 40 00 00:07:15.990 READ VERIFY SECTOR(S) EXT
42 00 00 57 06 07 40 00 00:07:15.780 READ VERIFY SECTOR(S) EXT
42 00 00 57 04 00 40 00 00:07:12.592 READ VERIFY SECTOR(S) EXT
SMART Self-test log structure revision number 1
No self-tests have been logged. [To run self-tests, use: smartctl -t]
SMART Selective self-test log data structure revision number 1
SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS
1 0 0 Not_testing
2 0 0 Not_testing
3 0 0 Not_testing
4 0 0 Not_testing
5 0 0 Not_testing
Selective self-test flags (0x0):
After scanning selected spans, do NOT read-scan remainder of disk.
If Selective self-test is pending on power-up, resume after 0 minute delay.